Knowledge Center

Approximate External Dimensions	4.5 x 2.5 x 1.5 in 115 x 65 x 40 mm
Material	Polycarbonate
IP Rating	IP65
UV Resistant	Yes
Waterproof	Yes

The following settings are configurable through the menu.  To adjust, remove the 4 screws that hold the front cover on the device and press the adjustment knob on the back side of the circuit board.  Twist the knob to scroll.

Accelerometer Sensitivity (0-9) 🔵
0 - Accelerometer OFF (will ignore reading and rely on only gyro)
1 - Minimum Sensitivity (will require high acceleration / vibration to trigger timer)
2 - 8 Sensitivity Increases at each level
9 - Maximum Sensitivity (very sensitive and will be susceptible to wind and nearby equipment)

Gyro Sensitivity (0-9) 🟢
0 - Gyro OFF (will ignore reading and rely on only accelerometer)
1 - Minimum Sensitivity (will require high rate of change to trigger timer)
2 - 8 Sensitivity Increases at each level
9 - Maximum Sensitivity (very sensitive and will detect very low rate of change)

Interval Setting (0.1 - 999.9 hours)
This adjusts the length of the timer

MotionMark checks for motion once every 15 seconds.  If motion is detected, remaining time is reduced.   Once the timer expires, it will continue counting to show "overdue" time while periodically flashing the red "timer expired" LED.

Hold the button for 3 seconds to reset the timer.  This can be done at any time.

Status LED

BLUE flash - accelerometer motion triggered
GREEN flash - gyro motion triggered
CYAN flash - both accelerometer and gyro motion triggered
RED flash - Low battery